BERETTA 92S grips (partially checkered)
Product code: B92S-2
Availability: In stock
Price: $75.00
These grips fit the original Italian Beretta model 92S, without the large circular hammer pin end on the gun (which is from the FS) and the corresponding cutout inside on the top of the left grip (this pin is found on the 92FS and 92F). Later transition pistols having the 92FS model's hammer pin and its large diameter head will not fit these grips. These grips are for guns with the slide-mounted safety only.
NOTE: Check the hammer pin (pivot) on your gun by removing the left grip panel. If your gun has the larger headed pin from the 92FS (over 3/8" diameter), these grips will NOT fit your gun and you can request our "TYPE 2" grips for the 92S. The TYPE 2 grips are machined to accommodate the larger head on the hammer pivot pins used later in the series. You may instead swap the pins out if you can source the smaller, original 92S pin, but this is your responsibility. The grips other than the Type 2 grips will not fit the large pin head unless you or your gunsmith alters the grip or pin.
These grips will fit the standard factory 92S; they will not accommodate added "enhanced" or "extended" fire controls such as safety levers or slide release levers.
The grips are carved out of naturally dried French walnut. We do not stain our grips, therefore each grip is unique in color and grain. To protect the surface of each grip, it is treated with a special mix of natural oils.
These grips are partially checkered.
Our grips have similar design and thickness as original plastic grips. These grips can be used by both right-handed and left-handed shooters.
Weight: 25g
Before any manipulation wiht the gun MAKE SURE it is UNLOADED.
Point the gun in a safe direction to unload it.
Pistols: Remove the magazine, clear the action and check barrel and chamber to ensure they are clear of any rounds.
Revolvers: Open the cylinder and remove any rounds. Double check to make sure no rounds remain in the weapon.
Remove Existing Grips as per the instructions of the manufacturer. Be careful not to damage the existing grips. Set aside and preserve the factory grips, as they might be a valuable part of the weapon and should you decide to sell the weapon they could increase the value.
Install New Grips
Please, refer to the instruction for each particular grip on the web page relating to that grip.
Clean the frame before installing new grips.
If new screws are supplied with the grips, use them. Otherwise use your original screws.
If the grips do not fit correctly, DO NOT FORCE THEM ON.
Certain grips appear to be a one piece grip, but are in effect 2 pieces pinned together. Carefully separate these grip panels to avoid breakage.
IMPORTANT NOTE: Only install grips on the frame for which they were designed. Even then, grips are not always a perfect fit right out of the package. Please, read the instructions and DO NOT attempt any alteration until you have done so. Also bear in mind the instruction by manufacturer of your wepon. Grips that have been modified in any way ARE NOT RETURNABLE.
After installing grips, CHECK YOUR GUN and make sure that all parts of the gun function correctly and without being obstructed or hindered by the grip.
Improper manipulation of any other internal component may affect the safety and reliability of your firearm and may cause serious injury or death.
NEVER ALLOW ANY ALTERATION OR REPLACEMENT OF PARTS IN YOUR FIREARM UNLESS PERFORMED BY A QUALIFIED GUNSMITH USING AUTHORIZED PARTS.